How to Fix a Leaking Roof

blog_img

A leaking roof is never a good thing. It can be a sign of something more serious, and can lead to substantial damage if not taken care of promptly. While most leaks can be patched with a few new shingles and a couple hours of your time, other leaks require roofing contractors Naperville IL to completely replace your roof. For easy fixes, here is a quick guide to help you through the process.

Step 1: Locate the source of the leak

This is not always an easy task. Before repair work can be performed, you’ll need to know where the leak is coming from. Where the water is dripping from inside your home is not always the same location as where the leak is. It is important to find the leak and get it repaired, before your whole roof suffers extreme damage.

The easiest way to locate a leak works if you have an attic. Go into the attic on a rainy day. The leaking water will reflect light, so be sure to take a flashlight along with you. Locate the source of the water, and mark the spot. On a nice day, have a helper go in the attic and tap on the mark while you are on the roof.

Step 2: Look for damaged shingles

Once you have located the source of the leak, look for damaged, curled, or missing shingles near where the water is getting in. If there are shingles that are curled back, use a blow dryer (do not use a torch or open flame) to soften the shingle. Reattach the curled shingles with asphalt roof cement or compound around the edges. Use a generous amount to prevent the shingles from curling up again.

Step 3: Replace any damaged or missing shingles

If you notice that you are able to lift your shingles with little effort, or that they break and crumble easily, they need to be replaced. Simply remove the old shingle by lifting up around the edges, and removing the roofing nails that are holding it in place. Scrape the area below where the shingle had been to remove any leftover roofing cement or nails. With the prep work done, you are ready to install new shingles. Slightly round the back corners of the new shingles using a utility knife, and then slide the shingle into place. Once in the right place, use large roofing nails in the upper corners to hold the shingle in place. Cover the nail heads with roofing cement.

Fixing a leaking roof is easier and a lot more cost effective than replacing the whole roof. But if you find that your roof is beyond a simple DIY roof repair, your friendly roofing contractors Naperville IL are willing to step in and do the job for you!

Leave a Reply

Your email address will not be published. Required fields are marked *