How to Install a Garbage Disposal

blog-image

If you are lucky enough, your new construction homes Naperville IL will come with a new garbage disposal already installed under your kitchen sink. For those of you who are not as lucky, or have an older home that never had a garbage disposal, you can easily install one with a few simple tools. Before you take the plunge and install a new garbage disposal, there are a few things that you need to be aware of.

First, the garbage disposal will attach to the underside of your kitchen sink, with discharge that attaches to the drain pipe. Your dishwasher’s (if you have one) outlet hose will also attach to the disposal. Secondly, if you do not already have a disposal in place, you’ll need to have an outlet and a switch nearby. Contact an electrician to install them if either one is missing. In some locations, a permit may be required, so check with your city before you begin work. Third, purchase the appropriate garbage disposal for your needs. Disposals typically are available in 1/3 or 1 horsepower. If you are on a septic system, be sure to purchase a disposal that is septic-safe. If you are not sure what disposal you should purchase, check a manufacturer’s recommendations to find the right disposal for your needs.

Now that you have the necessary equipment, you are ready to install your new garbage disposal!

Step 1:
Before beginning work, ensure that the circuit breaker to your kitchen is turned off! Once the breaker is off, you are ready to start installation. Place a bucket under the P-trap and disconnect the drain pipes to your sink. Remove the sink strainer and any excess putty.

Step 2:
Apply plumber’s putty around the flange on the new drain and press into place. Lay a towel in the sink and set the disposal on the flange to prevent it from moving.

Step 3:
Under the sink, stack the fiber gasket, backup flange, and mounting ring. Slide onto the underside of the flange. Install the snap ring by pulling it open and snapping into place. Tighten the screws evenly so they’re firmly against the backup flange, and clean up any excess putty.

Step 4:
Using a hammer, knock out and remove the drain plug from the inlet on the disposal to connect the dishwasher drain.

Step 5:
Remove the wire cover plate and connect the electrical cord by matching the wire colors. Once attached, push the wires back in and reattach the plate.

Step 6:
To connect the drain, insert the gasket in the discharge outlet, and then attach the discharge tube with the flange and bolts. Align the three tabs with the mounting ring to hang the disposal. Use the included wrench to turn and lock the tabs of the ridges. Connect the dishwasher drain, making sure that the discharge pipe is lined up properly, and connect your drainpipe. Use a T-pipe before your P-trap.

Step 7:
Now you are ready to test your newly installed disposal! Test your connections by placing the stopper into the sink drain and filling the sink with water. Check for leaks. Plug in the disposal and turn on the water.

Now with your new garbage disposal installed, you are good to go! No more having to prevent unwanted garbage from going down the drain. Installing a garbage disposal is an easy job around the house, but if you are looking for a new home that has a garbage disposal already installed, look at new construction homes Naperville IL. New homes will be equipped with all of the home conveniences that you would come to expect for a new construction.

Leave a Reply

Your email address will not be published. Required fields are marked *