Solid wood flooring is a vibrant and attractive surface that can add style to your home decor. If you want to upgrade to a new wood floor, you’ll have to go through the installation process. Here is a procedure for installing a wood floor for new construction homes Naperville IL:

    1. Choose the Right Materials: Hardwood flooring materials range from strips to planks. You may need to contact a contractor to advise you on choosing the right materials for your floor.
    2. Prepare the Installation Area: Start by measuring the room where you want to install the floor. When you’re done, add 10 percent extra to allow for fitting and cutting. Order the flooring materials and store them in your house for one to two weeks before carrying out the installation. This will give the materials time to acclimatize. For new construction homes Naperville IL, be sure to heat or air condition the room to maintain normal temperatures.
    3. Prepare the Subfloor: The subfloor should be a minimum of three-quarters of an inch thick. Depending on your preferences, it can be either a plywood subfloor or old wood flooring. Use drywall screws or wood to attach the joints and eliminate potential squeaks on the floor. Be sure to vacuum the floor to keep dirt out of the work area because even a small bump can alter the leveling.
    4. Install a Vapor Barrier: Keep off any vapor by using tap paper. If moisture is not an issue, you can use red rosin paper between the subflooring and flooring to eliminate friction between the layers.
    5. Lay Out the Installation: Install the flooring perpendicular to or across the floor joists to enhance maximum reinforcement and stability. You can use floor vents attached to the joists as a starting point for measuring. You should leave a half-inch gap around the perimeter of your room to give allowance for expansion and contraction.
    6. Install the Wood Flooring: Place the first board in the first row and align it with the chalk line. To avoid your hardwood from splitting, drill pilot holes on the gap edge and fix it to the subfloor using 10d finishing nails. Once the first row is firm, install the next row of boards using a power nailer and place two to three nails on every board. Boards should be locked tightly, leaving no gap that might get off the entire floor.
    7. Finish, Fill, and Trim Out the Floor: Use wood putty to fill any holes on the fixed nails or minor installation marks. Be sure to get putty that matches the color of your flooring. From there, you can trim out the walls around your room.




Following these guidelines and seeking advice from the contractors at Quality Design will help you succeed in installing a hardwood floor.